TouchTronics Invisilok - M115, Быстрый старт

Страница: 8 / 16

NST13308-M115-02_A ◄► 2021-06-23 ◄► Page 8
TROUBLESHOOTING - KEYLESS ENTRY
Possible Cause #4: Antenna Has Failed
Actions To Take:
• If the unlock switch is OK and there is +12V on the input pin #3 (Gray wire) when
the switch is pressed, unplug the antenna from the wire harness and then
reconnect it.
• Observe the QC Test
- The location code flashes twice:
- Data Bus Test - If the Data Bus is present, the Red LED flicker flashes for 10-seconds (if the antenna is at the
curbside door, the flicker flash is a short burst).
-Input Check - Both LEDs turn ON solid for 15-seconds.
• Unlock Switch Test
- Press the unlock switch
* If the unlock switch input is detected, the Green LED turns OFF and back ON.
* If this does not happen, either the unlock switch or the wire harness is defective.
* If you have determined that input is present on pin #3, then replace the antenna.
• Present the Wristband Key or Keychain Key to the antenna.
- If both LEDs don’t turn OFF when the key is present or when it is removed, then the antenna has failed.
- Replace the antenna.
1 Flash = Curbside Door 3 Flashes = Bulkhead Door
2 Flashes = Driver Door 4 Flashes = Rear Door
Pin 1 Pin 3