TouchTronics Invisilok - M115, Быстрый старт

Страница: 6 / 16

NST13308-M115-02_A ◄► 2021-06-23 ◄► Page 6
TROUBLESHOOTING - KEYLESS ENTRY
Possible Cause #4: The Wire Harness, Crimp, Ground Connection or Solenoid Has Failed
Actions ToTake:
• If the Red LED flashes when swiped with the Wristband Key or Keychain Key or the Unlock
switch is pressed, but the door does not unlock, check the truck harness and connector.
• Also check the solenoid output voltage on pin #3 (gray) which should be +12VDC any time
the green LED is ON for 6-seconds.
- If it is not +12V, check the truck wire harness, the ground, and the solenoid connections
and repair where needed.
Pin 1 Pin 3
Possible Cause #5: The Reader is OK but the Antenna Connector is Unplugged
Actions ToTake:
• Replug the antenna to the reader
- The antenna LED status LEDs should initiate the QC test sequence.
- Verify the antenna “sees” the Wristband Key or Keychain Tag by swiping it.
- If the Key is not detected, then recheck Possible Cause #3 above
Possible Cause #6: The Terminals on the Reader Harness or Antenna Harness are NOT Making
Proper Connection.
Actions ToTake:
• Check the connector pin outs and verify ground and power is present on the correct terminals.
1
2
3
4
5
Brown - Ground when Red is ON
White - RFID Signal
Violet - RFID Signal
Black - Ground when Green LED is ON
Red - +12VDC ON
Antenna
Connector
• To check for RFID signal, unplug the antenna and
check for continuity.
- If there is continuity between the White and
Violet wires, the circuit is OK.
}
Do NOT Test
With Voltmeter!!!