TouchTronics Invisilok - M115, Быстрый старт

Страница: 4 / 16

X
NST13308-M115-02_A ◄► 2021-06-23 ◄► Page 4
INSTALLATION
1. Identify the location of the remote antenna on the exterior of the truck, with the exception of the
bulkhead antenna. The bulkhead antenna is trypically installed on the cab side of the partition wall
between the cargo and cab.
2. The antenna should be placed in a location that is about 36-48” off the ground or floor and one that
is easy to access when swiping with the Wristband Key or Keychain Key.
3. The antenna range is 3-4” when using the Wristband Key or Keychain Key to unlock a door.
4, Drill a 2.5” hole in the truck body or partition wall.
5. Install the gasket onto the remote antenna as it is used to seal the antenna hole.
6. Insert the remote antenna into the opening, gasket on the exterior, and secure using the large nut.
It should be tight enough to prevent water leaking into the truck.
7. Within 36”, identify a mounting location for the reader. This should be in an area that is easy to
access for service and is not exposed to the elements.
8. An extension harness is available if the mounting distance is more than 36””
9. Install the switch at the Master Node location. It unlocks the door and auto relocks the same as a
key swiping the antenna. Each reader can be connected with a switch.
MOD-QC TEST INPUTS - ALL DOORS SHOULD BE CLOSED
Any time the Antenna/Reader is powered-up, the Mod-QC Test is executed and takes about
30-seconds. The red and green status LEDs emit a series of flashes which indicate the status of the
inputs to the Antenna/Reader. The Mod-QC Test interrogates the Antenna/Reader location inputs, the
data bus input and the inputs from the unlock switch and the RFID circuit. The Master Node controls
ALL of the data traffic in the keyless system.