8
1. Anchor the tank and the brackets with the
decorative screws that should be tightened by
hand.
Using the bracket to anchor the tank on the floor.
2. Install the tank on the floor with the screw.
1. Anchor the bracket with the attached
round-head screw.
2. Pass the constricted part of the tank
between the bracket and insert it the full
depth.
3. Insert the tank in the slit on the bottom
surface of the bracket and pass it through
the two holes.
INSTALLATION PROCEDURE - Tank
[ 0.8 gallon (3L) Tank Type ]
[ 0.26 gallon (1L) Tank Type (special order)]
Note
If the floor is made of concrete, embed the curl
plugs first.
4. Attaching the bundling band.
* The bundling band serves to prevent the
tank from falling off if the tank collides
with something.
If the tank is installed behind a wall, etc., it
is not necessary to attach the bundling
band.
Bracket
1. Decorative screw
Tank
2. Screw
Two round-head
screws
(
Φ
5.1 mm x 32 mm)
Bracket
Bracket
Wall surface
2. Insert it
the full depth.
Constricted part
Hole
Slit on the bottom of
the bracket
4. Bundling band
3.
EN
GL
ISH
9
2. Insert the hose fully into the controller and
put the hose clamp on the projection of the
joint to anchor the hose securely.
INSTALLATION PROCEDURE - Connecting Hoses and Cords
[ Tank side ]
[ Controller side ]
0.8 gallon (3L) Tank 0.26 gallon (1L) Tank
(special order)
* Connect the single type to only.
(The sensor does not work in any other
position.)
* Connect the double type to and .
( does not work.)
Hose
Hose clamp
Projection of joint
Liquid soap hose (clear)
Connect it to the tank.
Liquid soap hose (clear)
Connect it to the spout.
Air hose (blue)
Connect it to the spout.
Caution
Using a cutter, etc., cut the hoses so that the
cut surface becomes vertical.
1. Cut the hoses to an appropriate length that
reaches to the connected part.
(Between the spouts and the controller)
(Between the controller and the tank)
Caution
Connect the hoses and sensors in the
predetermined pairs.
When inserting the hoses, pay attention not
to apply strong force to the joint of the tank.
Pay attention not to bend the hoses.
Hose Connections
Connect the hoses
and sensors in the
predetermined pairs.
EN
GL
ISH