Page 10.4
Using Your Air Conditioner to Dehumidify
Using Your Air Conditioner to Dehumidify
If Cool to Dehumidify is ON the thermostat has the ability to initiate a
cooling cycle for advanced dehumidification operation. When the
thermostat detects the humidity percentage is above the setpoint for
dehumidification, and heating or cooling is not on, the thermostat
will force the compressor to run with the fan, thus reducing moisture
in the air. This feature will also allow you to adjust the cooling over-
shoot of the
0 to 5 (adjustable in step #10).
For
setpoint, from
Example: If the cooling overshoot is set for 3 F and the cooling setpoint is set
for 74 F, then as long as the room temperature reads between 71 F and 74 F
this feature will energize the compressor and fan to dehumidify the air.
°
°
°
°
°
°
Adjust the maximum
overshoot of the set
temperature in Cool to
Dehumidify mode.
Step 10 appears only if step 9 is set to “ON”
Select Cool to
Dehumidify feature.
On
Off
Press the PROGRAM button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
OFF
DeHumidify
Setup
9
C
OOL
DeHumidify
3
Setup
I0
PROGRAM
Press
MODE
Press
PROGRAM
MODE
MODE
Dehumidification Notes:
The thermostat must be in the Cool, Auto, or
Program On mode for the Cool to Dehumidify feature to be available.
Press the MODE button. While holding
the MODE, press the PROGRAM
button to enter Setup screens.
Press the MODE button repeatedly
until this setup screen appears.
Steps 9 and 10 only appear if the Dehumidification
setpoint is not 99% (see page 10.3).
TOTALINE
10
(0 - 5 )
Note: Press the
MODE
button momentarily
to move through the
setup screens. Press
and hold the
MODE
button to move back-
wards through the
setup screens.
Содержание P374-1 900
Страница 5: ......
