Make final adjustments
if required.
NOW DRILL SHED TO THE FLOOR
www.totalsheds.co.uk
© Sheds (Midlands) Limited 2021
STEP • 17
STEP • 16
Page 12
2ft ROOF SECTION
Place 2x6ft roof section last.
ATTACH THE ROOF FELT
Use the felt lengths provided.
16a. Place the 2ft roof section at the far
left end of roof if your shed size is a 6ft, 10ft, 14ft & 18ft.
16b. Please note that the roof sections should sit firmly on
the top of the front and rear panels and have the same
height as the side Pent Angle Tops.
16c. You will notice the gaps in
the roof as above. This is normal
and will be covered by the roof
felt material once applied.
17a. Apply the roof felt as shown. Apply lower levels
first to create correct rain run off positions.
17b. Using a hammer, tack down the felt
with the tacks provided in a neat fashion.
17c. Trim down excess felt with a stanley knife.
Remember to overlay the 1st felt to avoid rain leaks.
• 1st Section Lower Back
• 2nd Section Middle of roof overlaying section 1
17d. Tuck and fold edges neatly and tack in place
to hide any loose edges. Check that all areas are
covered and there are no holes to avoid any rain
water getting through your felt roof.
= Drill Points using
screws provided as shown
x4
4.0 x 70mm
STANLEY
KNIFE
HAMMER
1st Sheet at lower of roof
2nd Sheet in midde
3rd sheet on top front
Trim edges with 3” over
Fold & tack edges neatly
A
B
C
D
E
TACKS PROVIDED
16b.
• 3rd and last section on top front of roof overlaying section 2
DRILL
DRIVER
6x6ft • 6x10ft • 6x14ft • 6x18ft
SKIP Step
Jump to Step 17
NOTICE:
8x6ft
12x6ft
16x6ft
20x6ft
SKIP Step
SKIP Step
SKIP Step
