TOTAL GYM
®
XTREME OWNER’S MANUAL |
SET UP
6
Adjustable
Workout Card
Deck Holder
Holder Base
Vertical Column
IMPORTANT: Be sure the Spring Loaded Pin is locked
into place before using your unit. You will know the pin
is locked into place when you can see the end protrude
through the inside of the rail bracket.
6.
Position one foot on Back Crossbar to keep the product from
lifting off the floor. With one hand on either the right or left
rail and the other hand holding the Height Adjustment Quick
Release Pin out, slide the rails along the Vertical Column to
desired position and release pin. Pin will pop into place - you
will hear a snap. Insert Straight Safety Pin (attached to the
lanyard on the Height Adjustment Tube) through the hole on the
right side of the Height Adjustment Assembly.
NOTE: Insert Safety Hitch C Pin into side hole located
directly below Height Adjustment Assembly indicating
workout level on the Vertical Column.
8. ADJUSTABLE WORKOUT
CARD DECK HOLDER
ASSEMBLY
To add the Adjustable
Workout Card Deck Holder,
insert the Adjustable Workout
Card Deck Holder Base
into the Vertical Column.
Then secure the Adjustable
Workout Card Deck Holder to
the Holder Base.
7. SQUAT STAND ASSEMBLY
Assemble the Squat Stand at
the opposite end of the unit by
inserting it into the Front Crossbar
as pictured below. Make sure it is
fully inserted.
Front
Crossbar
Height Adjustment
Quick Release Pin
Insert Safety Hitch C Pin
into side hole located
directly below Height
Adjustment Assembly
indicating workout level
on the Vertical Column
Safety Hitch C Pin
The Adjustable Workout Card Deck Holder accommodates
tablets (horizontal layout only) with 22.8 cm / 9 in / 9 po max
width and mobile devices (vertical layout only) with minimum
11.9 cm / 4.7 in / 4.7 po height, maximum 19.05 cm / 7.5 in /
7.5 po height. The device’s maximum thickness is 1.8 cm / 0.7
in / 0.7 po.
NOTE:
Tablet/Mobile Device not included.
