Total Gym APEX G1, Руководство пользователя, Страница: 10 / 16

9 //
TOTAL GYM
®
//
SHOP
more attachments, accessories & tools at totalgymdirect.com
TOTAL GYM
®
// 10
ATTACHMENTS
LEG PULL ACCESSORY
REMOVE ALL
ATTACHMENTS
WHEN YOU ARE NOT
EXERCISING WITH
THEM.
NOTE: Be sure to have plenty of free space
—at least 2-3 feet of clearance around
the exerciser—so that performing on the
Total Gym
®
, as well as getting on and
off, is convenient and safe.The rails and
glideboard can be raised to any desired
level on the height adjustment assembly/
vertical column depending upon your
degree of fitness. Please note, however,
that the rails cannot be raised to the highest
position on the column when the leg
pulley bracket is attached to the top of
the column.
1. Connect the leg pulley bracket to the top
of the vertical column by aligning bracket
with the hole at the top of the column; be
sure bracket is right side up. Insert Large
Hitch Pin through the hole to secure bracket
onto the vertical column.
BRACKET
LARGE
HITCH
PIN
5. Position yourself on the glideboard
correctly for the specific exercise you want
to perform.
While sitting down on the glideboard, bring
1 knee up, connect the clip on the end of
the rope to an O-Ring on the Ankle Cuff
attached to your foot. Depending on the
exercise you are performing, connect the
clip to the proper O-Ring. Be sure to always
stabilize the glideboard when clipping on or
off the Ankle Cuff. Also, use caution when
getting on or off the glideboard. You are
now ready to exercise using the Leg Pull
Accessory. See your Exercise Guide
for specific exercises that utilize the
Leg Pull Accessory.
CLIP
O-RING
loose
O-RING
sewn in
O-RING
loose
NOTE: Remove leg pulley bracket when
you are not exercising with it.
To disconnect the Ankle Cuff, unclip the
rope from the O-Ring on the Ankle Cuff.
Be sure to stabilize glideboard when
disconnecting Ankle Cuff.
2. Detach the arm pulley/cable assembly
from the hook on the underside of the
glideboard and attach the O-Ring from the
leg pulley/rope assembly instead.
3. Place D-Ring on pulley first. Then connect
the D-Ring to the bracket as shown.
NOTE: If rope appears to be twisted,
take D-Ring off and turn pulley around.
BRACKET
D-RING
PULLEY
4. Attach the Ankle Cuff to one of your feet
by placing your foot in the harness so the
O-Ring (sewn in) is on the bottom of your
foot. With the strap threaded through the
harness buckle, pull tightly on strap securing
Ankle Cuff onto foot.
O-RING
sewn in
ANKLE CUFF
HARNESS
BUCKLE
O-RING
loose
O-RING
loose
PULLEY/D-RING
ASSEMBLY
ANKLE CUFF
CLIP
LEG PULLEY/ROPE ASSEMBLY
LEG PULLEY BRACKET
for use with Leg Pull Accessory only
WARNING
BE CAREFUL NOT TO BUMP
HEAD WHEN LEG PULL
ACCESSORY IS IN PLACE.
REMOVE LEG PULL ACCESSORY
FROM FRAME WHEN NOT
REQUIRED FOR THE
SPECIFIC EXERCISE.
WARNING 5
1 LARGE HITCH PIN
for use with leg pulley bracket
ROPE
O-RING