Total Control Products RCKP214, Руководство по установке

Страница: 40 / 41

3
10. Place supplied shaft #7900-094 into a
vise and cut square to the determined
length.
11. File to remove any sharp edges.
12. Paint the cut end of the shaft to protect
against rust.
13. Loosen the set screws on the two
u-joints and slide them as far apart as
they will go.
14. Insert the shaft into the upper u-joint.
15. Insert the shaft into the lower u-joint.
16. Slide the u-joints into position on the
rack and the column before tightening
the set screws.
17. Move the steering wheel through its
complete travel. There should be
any binding. If bind is detected in the
steering wheel you may need to shorten
the 3/4-DD shaft until the steering
moves freely.