Total Control Products RCKP214, Руководство по установке

Страница: 39 / 41

2
PARTS LIST
TCP ISFT-01 - Intermediate Shaft Kit 10” Long Shaft
Qty Part Number Description
1 7900-094 Shaft 3/4-DD x 10 long clear zinc plated
1 7900-UA10909 U-joint 3/4-DD x 3/4DD with 2 set screws
1 7900-165 U-joint 3/4-20 x 3/4DD with 2 set screws
INSTRUCTIONS
NOTE: A 1965 Mustang was used for the following images and may show slight differences from the later
Mustang and Cougar platforms. The installation procedure is identical.
1. To proceed, the instructions for the
steering column must be completed and
the rack and pinion bolted in place.
2. Place universal joint #7900-UA20109
onto the 3/4”-20 spline pinion shaft at
the rack. 1” of shaft engagement is
required.
3. Temporarily tighten setscrews just
enough to hold the u-joint in place.
4. Place universal joint #7900-UA10909
onto the exposed 3/4”- DD steering shaft
extending from the column.
5. One inch (1”) of shaft engagement is
required.
6. Temporarily tighten setscrews just
enough to hold the u-joint in place.
7. Angle the u-joints toward each other.
8. Measure the distance from point “A” to
point “B” as shown in the illustration.
This is your “cut to” length.
9. We recommend adding 1/4” to the
measured length if you are unsure of
the correct fit. The shaft can then be
shortened after test fitting.
A
B