
Type-A:
plain type bolt
Type-B:
with Spring Washer
1
2
3
5
P-600AL "Closet Cyclist 2" instructions manual
Upper Hook
Main Pillar
Lower Hook
Reinforcement Bar
Rear Leg
Right Side Front Leg
Height Adjuster
Leg Base Plate
Stainless Band Clip
• For use of normal human-powered 2-wheel bicycles only. Heavy and long bikes
such as tandem, electric assisted and downhill / freeride bikes don't fit P-600AL.
• P-600AL may lose balance when hanging bike on just one side only depends on
the bike weight. Be careful about the stability when taking off the bike.
• You should setup P-600AL along a wall to prevent falling backward problem. Do
not install the bike on the backside of P-600AL.
Required Tools for Assembling
Bolt Type Recognition
Install both right and left Front Legs to the
Leg Base Plate with the supplied M6x35
bolt (type-A), Flat washer, Collar and M6
Nylon nut. (see Fig. A)
M6 Nylon Nut
Collar
M6 Flat
Washer
Left Side
Front Leg
Place the Rear Leg on the Leg Base
Plate, and put the Pillar Base Plate
onto the assembled legs.
Put the M6x40 bolt (type-A) with
M6 Flat Washer into the front side
hole, then tighten to M6 Nylon Nut
temporarily. (see Fig. B)
Pillar Base
Plate
M6x40 Bolt (type-A)
Rear Leg
Put the M6x40 bolt (type-A)
with M6 Flat washer into the
backside hole and tighten to M6
Nylon Nut firmly.
After that, tighten the front side
bolt firmly too. (see Fig. C)
M6x40 Bolt
(type-A)
Attach the Backside Leg on the back
of the Main Pillar, then tighten with
the supplied two M6x18 bolts (type-B)
temporarily.
Please note that you will tighten
these bolts firmly after installing the
Reinforcement Bars. (see Fig. E)
Backside Leg
M6x18 Bolt
Main Pillar
1 x M5 Hex Wrench
1 x 10mm Spanner
1 x 13mm Spanner
M6x35 Bolt (type-A)
Leg Base Plate
MADE IN JAPAN
IMPORTANT NOTICES
Be sure the Legs are different
for right side and left side.
Each Reinforcement Bar must
be located inward.
!
M6 Nylon Nut
!
Be sure the collar insertion
direction is different on right
and left side. Follow as
shown in Fig. A.
(Fig. A)
(Fig. B)
(Fig. C)
(Fig. D)
(Fig. E)
M6 Nylon Nut
4
Insert the Main Pillar onto the Pillar
Base Plate.
Make sure the Main Pillar must cover
on the bracket, not placing beside the
bracket. (see Fig. D)
M6 Flat
Washer
M6 Flat
Washer
Stainless Band Clip
(2009/07)