Toshiba RAV-GM 1101UT-E, Руководство по обслуживанию

Страница: 94 / 125

– 94 –
10-2-2. Automatic Address Example from Unset Address (No miswiring)
1. Single
Only t u rning on s o u rce power su pply (A u tomatic completion)
1. Standard (One outdoor unit)
1-1
Individ u al
2. Twin
1-1
Ma s ter/Header
1-2
S u b/Follower
Only t u rning on s o u rce power su pply (A u tomatic completion)
2. Single group operation (Multiple outdoor units = Multiple indoor units only with serial communication)
2-1
S u b/Header
1-1
S u b/Header
3 -1
S u b/Header
4-1
Ma s ter/Header
8-1
S u b/Header
10-3. Remote Controller Wiring
• Strip off approx. 9 mm the wire to be connected.
• For single system, use non polarity, 2 core wire is
used for wiring of the remote controller.
(0.5 mm² to 2.0 mm² wires)
• For the synchronous twin system, use
2-conre shield wire (Vinyl cord for microphone 0.5
to 2.0 mm²) to conform to the EMC standard.
Wiring diagram
A
B
A
B
Terminal block for remote controller
wiring of indoor
u nit
Terminal block
Remote controller
u nit
Remote controller wire
(Proc
u red locally)
A B
1 2 3
A B
1
1
2
2
3
3
Remote controller
Remote controller
wiring
Indoor s ide
Indoor/O u tdoor
connecting wire s
O u tdoor s ide
Remote controller
inter-
u nit wiring
Indoor power
inter-
u nit wiring
Indoor s ide
∗
For details of wiring/installation of the remote
controller, refer to the Installation Manual enclosed
with the remote controller.
Simultaneous twin system
∗
Use 2-core shield wire (MVVS 0.5 to 2.0 mm² or more) for the remote controller wiring in the simultaneous
twin simultaneous triple and simultaneous double twin systems to prevent noise problems.
Be sure to connect both ends of the shield wire to earth leads.
∗
Connect earth wires for each indoor unit in the simultaneous twin simultaneous triple and simultaneous
double twin system.