Toshiba RAV-GM 1101UT-E, Руководство по обслуживанию

Страница: 83 / 125

– 83 –
1. Various settings available via the outdoor unit (Existing pipe, Maximum frequency
change, Snow guard fan control, Cooling only setup, etc.)
(1) Service switch setting
Various settings can be made using the service switches
[Method of operation]
1) Ensure the LED display shows the initial status. If not then ensure to restore the initial status.
2) Press SW01 for at least 5 seconds. D804 will start slowly flashing.
3) Push SW01 several times until reaching the required LED display function.
4) Push SW01 until D805 starts rapidly flashing.
5) Press and hold down SW02 for at least 5 seconds. D804 will start slowly flashing and D805 will light up,
and the various settings will take effect.
6) To make more settings repeat steps 3) to 5).
7) To invalidate any settings made in steps 1 to 3 press SW01 to turn off D805.
8) Press and hold down SW02 for at least 5 seconds. D804 will start to slowly flash and D805 will turn off
and the various settings will be invalidated.
∗
If any unclear point arises during an operation then can return to step 1 by pressing and holding down
SW01 and SW02 at the same time for at least 5 seconds.
Functions LED display Control content
Exi s ting
pipe s etting
D800 D801 D802 D80 3 D804 Activate when exi
s ting Ø19.1 piping i s us ed. Note that in
thi s ca s e, depending on the o u tdoor and indoor air
temperat u re, the heating capacity may drop.
Cooling only
s etting
D800 D801 D802 D80 3 D804 Cooling only
s etting. (Can al s o be changed us ing the DN
code [0F] on the wired remote control).
Snow g u ard
fan control
D800 D801 D802 D80 3 D804 The
s now g u ard fan control enable s s now to be diverted
from the path of the fan and heat exchanger, thereby
protecting the fan motor. And even when the compre
ss or
i s not in us e b u t the external temperat u re i s le ss than 7˚C
en su re the o u tdoor fan i s going us ing W 3 .
Maxim u m
freq u ency
change
D800
Model GP80 GP110
D801 D802 D80 3 D804 Enable thi
s if yo u wi s h to lower the maxim u m compre ss or
freq u ency. It will lower the maxim u m freq u ency d u ring
both cooling and heating. Note however it doe s red u ce
the maxim u m capacity.
Maxim u m compre ss or freq u ency (rp s )
Cooling Heating
Standard s tat us 80.4 99.6
When s etting i s valid 74.4 74.4
Cooling Heating
64.2 78.6
58.8 58.8
GP140
Cooling Heating
77.4 99.6
74.4 74.4
: Go ON : Go OFF : Fla s h (5 time s / s ec)