Toshiba RAV-GM 1101UT-E, Руководство по обслуживанию

Страница: 114 / 125

– 114 –
No. Part name Procedure Remarks
g
Electric
part
(Reactor)
3. Detachment (Reactor)
1) Following to work of Detachment of
f
2) Remove the connector of the reactor lead wire
connected to the reactor. (2 positions)
3) Remove the connector.
( Ø4 ST3T, 2 pcs,)
4. Attachment (Reactor)
Attach the reactor in the reverse process of the
“ 3. Detachment (Reactor) ”.
Re a ctor
Re a ctor le a d × 2
h
Fan motor
1.Detachment
1) Following to work of Detachment of
c
,
d
and
e
.
2) Make sure that the fan motor and the propeller fan
stop.
Remove the flange nut from the fan motor and
propeller fan.
• Loosen the flange nut by turning clock wise.
(To tighten the flange nut, turn it counter clockwise)
3) Remove the propeller fan.
4) Following to work of Detachment of
g
, 1) to 5).
Propeller f a n Propeller f a n
F a n motor F a n motor
Compressor c a se thermost a t le a d
(Bl a ck tu b e)
Cl a mp filter Cl a mp filter
4-w a y v a lve coil le a d 4-w a y v a lve coil le a d
(1 : Yellow , 1 : Red ) (1 : Yellow , 1 : Red )
Binding ba nd Binding ba nd
Binding ba nd A1
F a n motor le a d fixing ru bb er
S ep a r a te pl a te
Protrusion/refriger a tion
cycle side
Propeller f a n
F a n motor
Fl a nge nut
(Loose it tuning to right)
[Detail. C] [Detail. C]
Cl a mp filter
4-w a y v a lve coil le a d
(1 : Yellow , 1 : Red )
Binding ba nd A4
[Detail. C]
Re a ctor le a d Re a ctor le a d
(White × 2) (White × 2)
Re a ctor le a d
(White × 2)
P a ss the b inding ba nd A4
through the hole on the
cl
a mp filter, a nd then
b undle two re a ctor le a ds.
[Detail.C]
5) Cut the binding band A4 ( Thickness :1.1 mm, Width
:2.5 mm) bundling the case thermostat lead and the
reactor lead × 2
6) Remove the connector for the fan motor lead.
Remove the clamp filter from the fan motor lead.
(It is used after replacement.)
7) Remove the fan motor lead from the fixing rubber for
separate plate.