– 35 –
Item
8. Louver
control
1) Louver position setup
• When the louver position is changed, the position once moves to the most
downward position then return to the set position.
• The louver position can be set up in the following operation range.
2)
S
wing setup
• [
S
WING] is displayed and the following display is repeated.
In coolin
g
/dry operation
In all operation
s
(Repeats)
3) When the unit stopped or the warning was occurred, the louver is
automatically set to full closed position.
4) When PRE-HEAT (Heating ready) is displayed
(Before heating operation start or defrost operation is performing), or
during Themo-off in heating operation the louver is automatically set to
horizontal discharge position.
* The louvers which air direction is individually set or which position is locked
fully closed when the unit stops and the louver is automatically set to
horizontal discharge position when PRE-HEAT (Heating ready) is
displayed, or during Themo-off in heating operation.
<<Individual air direction
s
etup>>
In heatin
g
/fan operation
When louvers is in the
swing mode , they
move further to the
ceiling side than the
preset position when
swing mode is not on.
Individual air direction
can be set up by wired
remote controller.
Operation flow and applicable data, etc
De
s
cription
2
0
4
0
03
01
Drain pipe
Refrigerant pipe
1
Push the [
] / [
] button to select
“2. Individual louver” on the menu screen, push the
“
Set” [ F2] button.
2
Push the “
Louver No.” [ F1] button to
select the louver to set.
→
The display changes as follows each time the button is pushed.
Lo
u
ver 1
Lo
u
ver 2
Lo
u
ver
3
Lo
u
ver 4
All
3
Push the [
] / [
] button to select the wind
direction.
4
Push the [
CANCEL] button.
→
The screen returns to the menu screen.
