Toshiba MMU-AP0071MH, Руководство пользователя

Страница: 11 / 219

10
English-10
4
CORRECT USAGE
• When you use the air conditioner for the first time or when you change the SET DATA value, follow the
procedure below. From the next time, the operation displayed on the remote controller will start by pushing the
ON / OFF
button only.
„ „
„ „
„
Preparation
Turn on the main power switch and/or the leakage breaker.
• When the power supply is turned on, a partition line is displayed on the display part of the remote controller.
∗
After the power supply is turned on, the remote controller does not accept an operation for approx. 1 minute,
but it is not a failure.
REQUIREMENT
• While using the air conditioner, operate it only with
ON / OFF
button without turning off the main power switch
and the leak breaker.
• When you use the air conditioner after it has not been used for a long period, turn on the power switch at least
12 hours before starting operation.
Start
1
Push
ON / OFF
button.
The operation lamp goes on, and the operation
starts.
2
Select an operation mode with the
“MODE
MODE
” button.
One push of the button, and the display changes
in the order shown as follows.
• “ DRY mode” function is not provided to
Concealed Duct High Static Pressure Type.
3
Select air volume with “
FAN
” button.
One push of the button, and the display changes
in the order shown as follows.
• When air volume is “ AUTO”, air volume
differs according to the room temperature.
• In DRY mode, “ AUTO” is displayed and
the air volume is LOW.
• In heating operation, if the room temperature is
not heated sufficiently with VOLUME “ LOW”
operation, select “ MED.” or “ HIGH”
operation.
• The temperature sensor senses temperature near
the air inlet of the indoor unit, which differs from
the room temperature depending on the installa-
tion condition.
A value of setting temperature is the measure of
room temperature.
(“
AUTO” is not selectable in the FAN mode.)
• Air volume of function is not provided to
“Concealed Duct High Static Pressure Type” but
air speed “
HIGH” only is displayed.
4
Determine the set up temperature by pushing
the “TEMP.
” or “TEMP. ” button.
Stop
Push
ON / OFF
button.
The operation lamp goes off, and the operation stops.
HEAT DRY COOL FAN
Heat-pump model
DRY COOL FAN
Cooling only model
(Dehumidify)
AUTO HIGH MED. LOW
SET
TIME
TIMER SET
TEST
FILTER LL
RESET
TEMP.
CL
FAN
SAVE A A
SWING/FIX
VENT
MODE
ON / OFF
UNIT LOUVER T
2
3
1
4