Toshiba GD-1221, Руководство оператора

Страница: 57 / 264

Specifying the Remote Fax 55
Memory Transmission
The original is scanned into memory and automatically starts to be sent once a connection has
been made.
y The default setting is memory TX, however you can set direct TX as the default, To change
the default setting from memory TX to direct TX, see
P.183 “Memory transmission”.
y Even if the memory TX mode is selected as the default, you can use the [DIRECT TX] key to
perform direct TX temporarily. For details of temporary direct TX, see
P.89 “Direct trans-
mission”.
y You can send the original whenever the standby mode screen is displayed.
- You can send the original even while memory TX, receiving a Fax document or printing
report/list is being performed.
- When the remote Fax line is available, the equipment begins dialing after the first page is
scanned to memory.
- If the original cannot be sent (the remote Fax is busy or otherwise unavailable), the
remote Fax is automatically redialed repeatedly.
y Originals are scanned at high speed and stored to memory, therefore you can return
originals to their files immediately.
- When the amount of memory remaining for memory TX usage reaches 0, the original is
automatically transmitted in the direct transmission mode.
- Up to 100 transmissions can be reserved.
y Page on which error occurred is automatically transmitted again. (ECM function)
- ECM (Error Correction Mode) is an internationally standardized communication mode
that automatically corrects errors that occur during Fax transmissions.
y File Number and Residual Memory
- The equipment assigns a File Number to each transmission or polling-reception job for
internal control of reserved communications. This File Number is very useful, should it
become necessary to cancel a memory operation. It is also useful when tracking commu-
nication activities using the transmission and reception journals.
- The amount of memory remaining for memory TX usage is called Residual Memory and
is displayed as a percentage value.
When using the (Reversing) Automatic Document Feeder (optional)
The Group Dialing number and the name of the remote party appear on the LCD
display for about 2 seconds, and the equipment automatically starts scanning and
sending the document.
y If a Group Dialing number is not
programmed, the message
"Number not listed" is displayed
for 2 seconds and the display
returns to the previous status
screen.
y The screen on the right may
appear when the equipment has
failed to detect the original size.
In this case, re-place the origi-
nal, or select the original size
using the
or button and
press the [ENTER] button.
TELEPHONE NUMBERS LIST
Number not listed
GROUP NUMBER: 0088
Select original size
2.LD
3.LT-R
1.LT