Torqeedo Ultralight 1103 AC, Руководство по эксплуатации

Страница: 47 / 66

Error messages
EN DE
Display Cause What to do
E21 Incorrect calibration of accelerator lever Recalibrate:
1. Press the CAL button for 10 seconds.
cal up appears on the display.
2. Set the accelerator lever to full throttle forwards.
3. Press the CAL button.
cal stp appears on the display.
4. Set the accelerator lever to the neutral (stop) position.
5. Press the CAL button.
cal dn appears on the display.
6. Set the accelerator lever to full throttle reverse.
7. Press the CAL button.
E22 Magnetic sensor defective Recalibrate; see "E21" . If the error code appears several times, then con-
tact Torqeedo Service.
E23 Value range incorrect Recalibrate; see "E21" .
E30 Communication error with motor Check the cables and the plug connections of the data cables.
If necessary, contact Torqeedo Service and tell them the error code.
E32 Communication error for accelerator lever Check the plug connections of the data cables.
Check the cables.
E33 General communication error Check the plug connections on the cables.
Check the cables.
Switch the motor off and on again.
page 111 / 128