Toro Ultra Sonic Boom 41219, Руководство по установке

Страница: 11 / 16

7. Install the battery terminal on the wiring harness to the
positive (+) terminal of the battery.
8. Lower the driver's seat.
Installing the Sonic Boom Switch
1. Route the end of the wiring harness with the sonic
boom switch connector under the dashboard.
2. Remove the switch plug on the dashboard in the
location shown in Figure 21.
Figure 21
1. Plug on the dashboard
3. Insert the rocker switch in the dashboard opening.
4. Connect the switch connector on the wiring harness
to the switch.
Installing the Indicator Light and
Connecting the Switches
1. Remove the right-hand side cover on the center console
by removing 5 bolts and a long screw.
2. Disconnect the connections from the 2 existing boom
lift switches that control the left-hand and right-hand
booms.
Note:
Tuck the connectors from the old wiring
harness away.
3. Remove the plug and insert the indicator light into the
hole in the console.
4. Connect the indicator light to the connector on the
wiring harness.
5. Connect the 2 boom lift (rocker) switches to the
connectors on the wiring harness.
Note:
The 2 connectors on the wiring harness
are labelled Left Boom Raise/Lower and Right Boom
Raise/Lower .
6. Install the right-hand side cover on the center console
using the fasteners that you removed in step 1.
7. Route the wiring harness to the back of the vehicle
along the path of the other wires and hoses.
Note:
Use cable ties to secure the wiring harness
to the other wiring harnesses away from the exhaust
system and any moving parts.
8. Connect the Left Boom/Up; Left Boom/Down
connectors on the wiring harness to the solenoid valves
on the hydraulic block (Figure 22).
g018639
1
2
3
4
Figure 22
1. Left Boom/Down 3. Right Boom/Up
2. Left Boom/Up 4. Right Boom/Down
Note:
The connectors on the wiring harness are
labeled Left Boom/Up; Left Boom/Down; Right
Boom/Up; and Right Boom/Down.
Note:
There should be 2 open connectors that remain;
they are for connecting the sensors.
9. Secure the Right Enable and Left Enable wires with cable
ties.
10. Install the mounting plate over the hydraulic block.
Connecting the Sensors
1. Route the wire from each sensor along the boom
toward the rear center of the machine.
2. Secure the sensor wires to the boom with cable ties.
Note:
Ensure that you allow enough slack in the wire
near the sensors so that the sensors can freely pivot
on the hinges.
3. Connect the left and right sensor end connectors to
the wiring harness connectors labeled
Left Sonic Sensor
and Right Sonic Sensor , respectively.
11