Toro Ultra Sonic Boom 41219, Руководство по установке

Страница: 10 / 16

4. Route the wiring harness to the hydraulic manifold
(Figure 17).
5. Route the electronic control terminal on the wiring
harness through the knockout hole, but do not connect
the terminal to the controller.
6. Install the mounting bracket to the machine seat frame,
between and behind the seats with existing hardware
(Figure 15).
7. Secure the controller to the mounting bracket with 4
hex head bolts (1/4 x 1-1/8 inch) and 4 locknuts.
7
Installing the Wiring Harness,
Indicator Light, and the
Switches
Parts needed for this procedure:
1 Wiring harness
1 Rocker switch
1 Indicator light
12 Cable tie
Connecting the Wiring Harness to the
Electronic Controller, Ground Block,
Main Power Source, and Battery
1. For model 5800 , connect the terminal on the wiring
harness into the electronic controller and secure it with
an Allen wrench (Figure 18).
Figure 18
1. Electronic controller 2. Terminal
Note:
The controller connection is keyed and can be
connected in only one way.
2. For model 1750 , connect the wiring harness to the
electronic controller by routing the wiring harness
under the cover (Figure 19).
1
2
g025930
3
Figure 19
1. Wiring harness 3. Electronic controller
2. Cover
3. Lift the seat to access the fuse block area.
4. Locate the existing fuse blocks on the machine, and
install the fuse block connected to the wiring harness
by securing it to the bottom of the fuse block above it
(Figure 20).
Figure 20
1. Ground terminal block 2. Fuse block
5. Secure the ground terminal on the wiring harness to
the ground terminal block (Figure 20).
6. Connect the wiring harness connector labeled “Main
Power” to the main power source connector by the
fuse block.
10