Toro Ultra Sonic Boom 41219, Руководство по установке

Страница: 8 / 16

1
2
4
3
3
5
G017151
6
7
8
Figure 13
Uncovered boom configuration shown
1. Cover 5. Cap tube
2. Sensor 6. Bolts (5/16 x 1-1/4 inch)
3. Large nut
7. Locknuts (5/16 inch)
4. Lower sensor housing 8. Finished sensor assembly
5. Install the programming plug on the sensor (Figure 14).
Important:
Ensure that you align the arrow below
the sideways “T” with the notch on the top edge
of the sensor (Figure 14).
G017158
1
2
3
4
Figure 14
1. Sideways “T”
3. Notch
2. Arrows aligned 4. Sensor
6. Insert the sensor into the lower sensor housing, and
secure it with 2 large nuts provided with the sensor
(Figure 13).
Note:
Discard the lock washers that come with the
sensors.
7. Install the cap tube and the cover (Figure 13).
Note:
Ensure that the sensor wire is routed through
the small opening in the cover before installing the
sensor cover.
8. Secure the wire coming from the sensor to the boom
with cable ties.
Important:
Ensure that you allow enough slack
in the wire around the sensor so that the sensor
can freely pivot on the hinge without pulling on
the wire.
9. Repeat the steps above for the other boom.
Note:
For covered booms only: The sensors should not
detect the boom cover as this may interfere with the signal. If
you experience any difficulties during the calibration process,
check the sensors to ensure that their signals do not detect
the boom cover.
8