Toro Super Recycler 20792, Руководство пользователя

Страница: 8 / 120

4. Lock the handle at your desired height. Refer to
Adjusting the Handle Height (page 11) .
5. Torque the handle bolts to 14 to 17 N∙m (120
to 160 in-lb).
6. Adjust the cutting height. Refer to Adjusting the
Cutting Height (page 11) .
2
Installing the Recoil-starter
Rope in the Rope Guide
No Parts Required
Procedure
Important:
To start the engine safely and easily
whenever you use the machine, install the
recoil-starter rope in the rope guide.
Hold the blade-control bar to the upper handle and
pull the recoil-starter rope through the rope guide on
the handle (
Figure 5 ).
g003251
Figure 5
1. Recoil-starter rope 2. Rope guide
3
Filling the Engine with Oil
No Parts Required
Procedure
Important:
Your machine does not come with oil
in the engine. Before starting the engine, fill the
engine with oil.
Engine Oil Specifications
Engine Oil Specifications (cont'd.)
Engine oil capacity 0.44 L (15 fl oz)
Oil viscosity SAE 30 or SAE 10W-30
detergent oil
API service classification SJ or higher
1. Move the machine to a level surface.
2. Remove the dipstick by rotating the cap
counterclockwise and pulling it out (
Figure 6 ).
g187518
Figure 6
1. Dipstick 3. Full
2. Add
3. Carefully pour about 3/4 of the engine capacity
of oil into the oil-fill tube.
4. Wait 3 minutes for the oil to settle in the engine.
5. Wipe the dipstick clean with a clean cloth.
6. Insert the dipstick into the oil-fill tube, then
remove the dipstick.
7. Read the oil level on the dipstick ( Figure 6 ).
•
If the oil level on the dipstick is too low,
carefully pour a small amount of oil into the
oil-fill tube, wait 3 minutes, and repeat steps
5 through 7 until the oil on the dipstick is at
the correct level.
•
If the oil level on the dipstick is too high, drain
the excess oil until the oil on the dipstick is
at the correct level; refer to
Changing the
Engine Oil (page 21) .
Important:
If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
8. Install the dipstick into the oil-fill tube securely.
7