Toro Super Recycler 20792, Руководство пользователя

Страница: 12 / 120

is at the correct level. For the oil type, refer
to
Changing the Engine Oil (page 21) .
•
If the oil level on the dipstick is too high
(
Figure 12 ), drain the excess oil until the oil
on the dipstick is at the correct level; refer to
Changing the Engine Oil (page 21) .
Important:
If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
6. Install the dipstick into the oil-fill tube securely.
Adjusting the Handle
Height
You may raise or lower the handle to a position
comfortable for you.
Rotate the handle lock, move the handle to 1 of 3
positions, and lock the handle into position (
Figure
13 ).
g007284
Figure 13
1. Handle lock 2. Handle positions
Adjusting the Cutting
Height
WARNING
Adjusting the cutting height may bring you
into contact with the moving blade, causing
serious injury.
• Shut off the engine and wait for all moving
parts to stop.
• Do not put your fingers under the housing
when adjusting the cutting height.
CAUTION
If the engine has been running, the muffler
will be hot and can severely burn you.
Keep away from the hot muffler.
Adjust the cutting height as desired. Set all 4 wheels
to the same height. To raise and lower the machine,
refer to
Figure 14 .
g189041
Figure 14
During Operation
During Operation Safety
General Safety
•
Wear appropriate clothing, including eye
protection; slip-resistant, substantial footwear; and
hearing protection. Tie back long hair, secure
loose clothing, and do not wear jewelry.
•
Do not operate the machine while ill, tired, or
under the influence of alcohol or drugs.
•
The blade is sharp; contacting the blade can result
in serious personal injury. Shut off the engine,
remove the electric-start button (electric-start
model only), and wait for all moving parts to stop
before leaving the operating position.
11