Toro STX-26, Руководство оператора

Страница: 36 / 48

g011476
Figure 51
1. Traction rod 2. Jam nut
E. Start the machine and set the throttle to
about the 1/3 open position.
WARNING
When the machine is running, you
could be caught and injured in
moving parts or burned on hot
surfaces.
Stay away from pinch points, moving
parts, and hot surfaces when
adjusting the running machine.
F. Have a helper hold the traction control tight
to the reference bar in reverse.
G. Adjust the length of the traction rods until
both tracks are running at the same speed.
Note:
You can also adjust the maximum
reverse speed of the tracks at this time.
H. Tighten the jam nuts.
I. Adjust the traction control so that it rests
flush against the reference bar when it is
pulled straight back (
Figure 49 and Figure
50 ).
J. Tighten the flange nut and bolt in the
traction control stem.
K. Shut off the engine and lower the machine
to the ground.
L. Drive the machine in full reverse, checking
to see if the machine tracks straight. If it
does not, note the direction the machine
veers. Repeat the adjustment so that the
machine tracks straight in reverse.
Adjusting the Traction-Control
Neutral Position
If the machine creeps forward or backward when
the traction control is in neutral and the machine is
warm, you may need to adjust the return-to-neutral
mechanism on the pumps; contact your Authorized
Service Dealer.
Adjusting the Traction-Control
Forward Position
If the machine does not drive straight when you hold
the traction control forward against the reference bar,
complete the following procedure:
1. Drive the machine with the traction control
against the reference bar, noting which direction
the machine veers.
2. Release the traction control.
3. If the machine veers to the left , loosen the right
jam nut and adjust the tracking set screw on the
front of the traction control (
Figure 52 ).
4. If the machine veers to the right , loosen the left
jam nut and adjust the tracking set screw on the
front of the traction control (
Figure 52 ).
g004194
Figure 52
1. Set screw 3. Stop
2. Jam nut
5. Repeat the procedure until the machine drives
straight in the full forward position.
Important:
Ensure that the set screws touch
the stops in the full forward position to avoid
overstroking the hydraulic pumps.
36