Toro STX-26, Руководство оператора

Страница: 18 / 48

g013420
Figure 17
5. Move the machine forward a few centimeters
(inches) and repeat step
4 ( Figure 17 ).
6. Repeat steps 4 through 5 until you have ground
off the entire face of the stump ( Figure 17 ).
7. Back up the machine, position the grinder to the
side of the front of the stump, and lower it to
about 2 cm (1 inch) below the surface.
8. Repeat steps 4 through 7 until the stump is
ground away.
9. If there are any large roots to be ground, position
the grinder over each root and use the traction
control and grinder control to move the grinder
along the root, grinding it away.
10. Clean debris from the hydraulic lift, drives,
mufflers, and engine after each use; refer to
Removing Debris from the Machine (page 40) .
Moving a Non-Functioning
Machine
Important:
Do not tow or pull the machine
without first opening the tow valves, or you will
damage the hydraulic system.
1. Engage the parking brake and lower the
hydraulic lift.
2. Shut off the engine and remove the key.
3. Remove the bottom shield.
4. Using a wrench, turn the tow valves on the
hydraulic pumps twice counter-clockwise (
Figure
18 ).
g013179
Figure 18
1. Tow valves
5. Install the bottom shield and tow the machine
as required.
6. After repairing the machine, close the tow valves
before operating it.
Securing the Machine for
Transport
Important:
Do not operate or drive the machine
on roadways. Use care when loading or unloading
the machine into a trailer or truck.
1. Park the machine on a level surface, engage
the parking brake (if applicable), and lower the
hydraulic lift.
2. Shut off the engine and remove the key.
3. Secure the machine to a trailer with chains or
straps using the tie-down/lift loops at the front
and rear of the machine (
Figure 19 and Figure
18