Toro Spray Master, Руководство оператора

Страница: 56 / 88

g312873
Figure 70
1. Filler neck 3. Maximum oil level
(dipstick)
2. Dipstick 4. Minimum oil level (dipstick)
5. Remove the dipstick from the filer neck, and
check oil level on the dipstick (
Figure 70 ).
Note:
The engine oil level must cover the
hatch-marked area of the dipstick ( Figure 70 ).
6. If the oil level is low, wipe off the area around the
filler neck and add the specified oil (
Figure 71 )
until the oil level is between the hatch marked
areas on the dipstick.
Important:
Do not overfill the engine with
oil.
g312871
Figure 71
Changing the Engine Oil
and Engine-Oil Filter
Service Interval: After the first 5 hours
Every 100 hours (more often under severe
condition).
Draining the Engine Oil
1. Prepare the machine for maintenance; refer to
Preparing the Machine (page 51) .
2. Align the oil-drain hose out the left side of the
machine, and remove the plug from the hose
(
Figure 72 ).
Note:
Allow the engine oil to drain completely.
g312973
Figure 72
1. Drain hose 3. Install the drain plug into
the hose.
2. Plug
3. Install the drain plug into the hose, and tighten
the plug (
Figure 72 ).
Note:
Wipe clean any residual oil.
56