Toro Sand Pro 3020, Руководство оператора

Страница: 8 / 28

*(
04& Install the rear wheels to the machine while it is
still on the pallet shipping blocks.
Mount a wheel to each wheel motor and secure
with lug nuts. Tighten lugs nuts evenly and gradually in
a crisscross manner to 45-55 ft-lb.
Remove the banding securing the machine to the
pallet.
Place a jack under square tube of frame (Fig. 1).
*(52&
5#5-"2 '2".&
04& 02 2&.06"- 0' 4)& 3)*11*/( #-0$,3 1-"$& 4)&
+"$, 0/-8 5/%&2 4)& 45#5-"2 '2".& 0 /04 1-"$& +"$,
5/%&2 4)& 7)&&- .04023 02 %"."(& $05-% 2&35-4
Jack up the machine, remove the shipping blocks
and lower the machine onto the rear wheels.
04& We suggest saving the shipping blocks, as they
are the correct height for blocking the unit when
changing tires, servicing wheel motors or performing
other service work.
*(
Move front wheel so it points straight ahead.
Slide steering wheel onto steering shaft aligning
mounting holes.
Secure steering wheel in place with roll pin.
*(52&
4&&2*/( 7)&&-
0-- 1*/
*(
Secure seat to seat plate with (4) 5/16-18 x 5/8" lg.
capscrews (Fig. 3).
Move lever on right side of seat outward, slide seat
to desired position and release lever to lock seat into
position.
*(52&
&"4
&"4 1-"4&
!
*(
If Battery is not filled with electrolyte or activated,
bulk electrolyte with 1.260 specific gravity must be
purchased from a local battery supply outlet and
added to battery.
Remove filler caps from battery and slowly fill each
cell until electrolyte is up to fill line.
Replace filler caps and connect a 3 to 4 amp
battery charger to the battery posts. Charge the battery
at a rate of 3 to 4 amperes for 4 to 8 hours.
When battery is charged, disconnect charger from
electrical outlet and battery posts. Allow battery to sit
for 5-10 minutes.
Remove filler caps. Slowly add electrolyte to each
cell until level is up to fill line. Install filler caps.