+)
The brakes have been set, at the factory, for optimum
performance but after use and wear an adjustment
may be required.
Park the machine on a level surface, turn engine off
and block wheels.
Loosen jam nut on actuator rod. Remove cotter pin
retaining actuator rod. Increase or decrease actuator
rod length by rotating rod. Reinstall actuator rod using
a new cotter pin and secure jam nut.
If modifying actuator rod length does not improve
brake performance, adjust both left and right
adjustment rods equally using the same procedure
described in step 2.
+)63'
%56#513 1&
&,645/'05 1&
#/ 65
155'3 2+0
+)
If implement fails to Float" when lift lever is in detent
position an adjustment to the lever guide is required.
Park the machine on a level surface, turn engine off
and engage parking brake.
Disconnect implement from lift cylinder and extend
cylinder part way.
Loosen capscrews and locknuts securing lever
guide to valve shroud.
Move lever guide until cylinder moves freely when
lift lever is in the detent position.
Tighten
capscrews
and
locknuts
locking
adjustment.
+)63'
+(5 .'7'3
'7'3 )6+&'
"
If the machine will be stored for more than 30 days,
remove the battery and charge it fully. Either store it on
the shelf or on the machine. Leave the cables
disconnected if stored on the machine. Store the
battery in a cool atmosphere to avoid quick
deterioration of the charge in the battery. To prevent
battery from freezing, make sure it is fully charged. The
specific gravity of a fully charged battery is 1.250.
"
Battery electrolyte level must be properly
maintained and the top of the battery kept clean. lf the
machine is stored in a location where temperatures are
extremely high, the battery will run down more rapidly
than if the machine is stored in a location where
temperatures are cool.
!'#3 4#('5: )1)).'4 #0& 36$$'3 ).17'4
8*'0 813-+0) 8+5* '.'%531.:5' *#3)' 5*'
$#55'3: +0 # 8'.. 7'05+.#5'& 2.#%' 41 )#44'4
231&6%'& 8*+.' %*#3)+0) %#0 &+44+2#5'
+0%' 5*' )#4'4 #3' '92.14+7' -''2 12'0
(.#/'4 #0& '.'%53+%#. 42#3- #8#: (31/ 5*'
$#55'3: &1 015 4/1-' #64'# /#: 3'46.5
+( 5*' )#4'4 #3' +0*#.'& 02.6) %*#3)'3
(31/ '.'%53+%#. 165.'5 $'(13' %100'%5+0) 51
13 &+4%100'%5+0) %*#3)'3 .'#&4 (31/ $#5;
5'3: 21454
Содержание Sand Pro 3020
Страница 26: ... ...