Toro REELMASTER 2300-D, Руководство оператора

Страница: 23 / 29

GREASING BEARINGS AND BUSHINGS
(Fig. 20–26)
The traction unit and cutting unit’s grease fittings must
be lubricated regularly with No. 2 General Purpose
Lithium Base Grease. If the machine is operated under
normal conditions, lubricate bearings and bushings after
every 50 hours of operation. Bearings and bushings
must be lubricated daily when operating conditions are
extremely dusty and dirty. Dusty and dirty operating
conditions could cause dirt to get into the bearings and
bushings, resulting in accelerated wear.
The traction unit bearings and bushings that must be
lubricated are:
Steering column (Fig. 20), steering gears (2) (Under
skirt below steering sector), steering shaft (2) (Fig. 21),
lift arms (3) (Fig. 22), rear lift cylinder pivot (Fig.24),
traction pedal pivot (Fig 25).
Also, apply grease to slots in cylinder support (Fig. 26).
Figure 20
23
Fluid
Type
Capacity
Change
Fluid
Change
Filter
Filter
Part No.
Engine oil
SAE
10W30 CD
3.0 l 50 hours 100 hours 85-4930
Hyd. circuit oil
Mobil 424 12.5 l 400 hours 200 hours 54-0110
Fuel filter 200 hours
Perkins
130366040
Air cleaner
Clean every 50 hours 200 hours 93-2195
Fuel
No. 2
Diesel
Coolant
50/50
Ethylene gly-
col water
4.7 l
Drain and flush, 2 years
24.5 l
Quick Reference Aid
1. Engine oil level
2. Engine oil drain (17mm socket)
3. Hydraulic oil level—Center of sight glass
4. Belts (Fan/water pump, hydraulic pump)
5. Coolant level fill
6. Fuel—Diesel only
7. Grease points
8. Radiator screen
9. Air cleaner
10. Water separator/fuel filter
11. Battery
12. Tire pressure:
(.8–1.1 bar) front
(.6–.7 bar) rear
13. Fuses