37
Installing the Spark Plug
s
1. Install the spark plugs and metal washers.
2. Tighten the spark plugs to 18 to 22 ft-lb (24.4 to
29.8 N
⋅
m).
3. Push the wires onto the spark plugs (Fig. 52).
4. Close and latch the seat.
Replacing the Fuses
There are 2 fuses and 2 empty slots in the electrical system.
They are located beneath the seat (Fig. 54).
Main electrical system
30 amp
Spray system
10 amp
Open
20 amp
Open
30 amp
1
2
3
4
Figure 54
1.
Main electrical system
2.
Spray system
3.
Open 20 amp
4.
Open 30 amp
Servicing the Battery
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals
known to the State of California to cause cancer
and reproductive harm. Wash hands after
handling.
Warning
Important
Do not jump start the sprayer.
Always keep the battery clean and fully charged. Use a
paper towel to clean the battery and battery box. If the
battery terminals are corroded, clean them with a solution
of four parts water and one part baking soda. Apply a light
coating of grease to the battery terminals to prevent
corrosion.
Voltage: 12 volt with 280 cold cranking Amps @ 0
°
F
Removing the Battery
1. Position the sprayer on a level surface, set the parking
brake, stop the pump, stop the engine, and remove the
ignition key.
2. Loosen the knobs on the sides of the battery box and
remove the battery cover (Fig. 55).
1
1
2
Figure 55
1.
Knobs
2.
Battery
3. Remove the battery retainer and fasteners (Fig. 55).
