Power-Up Diagnostics
Upon power-up, the SmartHub will display:
Gateway TM Booting
The SmartHub TM will initiate a diagnostic test automatically during power-up. This function will take approximately ten
seconds and it cannot be bypassed. If a problem is detected during the diagnostic test, it will be indicated on the display.
The status information cannot be edited. The information is as follows:
Line 1: SmartHub Firmware Version and Revision Date
Line 2: Number and type of daughterboards detected
Line 3: Last Power Downtime Date and Time
Example:
Rev: 2.01p16,12/02/19
Detect: 2 DC DBoards
PD 12/11/19 09:00:51
The default Home display will follow after the diagnostic display
has timed-out. Home display example:
Home Button
Pressing the Home button will revert to the default display. When editing irrigation programs, Station or SmartHub
settings, pressing the Home buton will save any setting modifications and return the user to the Home display.
Home display examples:
The GW# line displays the address of the controller. In the example above, the address of the SmartHub is Group 3. The
address of the first station board is 01. The second station board address is 02.
The Day Change line displays the next program start time (Next Start: HH:MM) if the current day is an active watering
day. If the SmartHub is running a program, the Day Change line will display
Running XX programs
to indicate
the number of active programs.
Sun 04/02/19 05:57am
GW# 03:01-02 Sec: 57
Day Change: 03:00pm
Next Start:
06:00am
Lynx Smart Hub LSM
Sun 04/02/19 06:01am
GW# 03:01-02 Sec: 57
Day Change: 03:00pm
Running 1 SBF List
P01 01-002 0:09:55L
Sun 04/02/19 05:59am
GW# 03:01-02 Sec: 57
Day Change:
03:00pm
(typical Home display
with no active scheduled program)
(Example of home display while
watering from a list. It is showing
station 2 running with 9 minutes
and 55 seconds remaining. It also
shows the station setup as a switch.)
26
Lynx® SmartHub Installation and User Guide
