Toro LT2240, Руководство оператора

Страница: 48 / 68

g348714
Figure 75
1. Track rod assembly 3. Rod end
2. Jam nut
2. Align the wheels by rotating the track rod ( Figure
75 ).
Note:
Use the wrench flats of the track rod to
turn it.
3. At axle height, measure the distance between
the front of the rear wheels and between the
rear of the rear wheels.
Note:
The wheels are aligned if the difference
between the front and rear measurements are 5
mm (0.20 inch) or less.
g348713
Figure 76
1. Front measurement 2. Rear measurement
4. Repeat steps 2 and 3 until the wheels are
aligned.
5. Tighten the 2 jam nuts to secure the track rod
assembly and the rod ends (
Figure 75 ).
Cooling System
Maintenance
Cooling System Safety
•
Swallowing engine coolant can cause poisoning;
keep out of reach from children and pets.
•
Discharge of hot, pressurized coolant or touching
a hot radiator and surrounding parts can cause
severe burns.
– Always allow the engine to cool at least 15
minutes before removing the radiator cap.
– Use a rag when opening the radiator cap, and
open the cap slowly to allow steam to escape.
Removing Debris from the
Cooling System
Service Interval: Before each use or daily
Every 100 hours
Note:
To prevent the engine from overheating, keep
the radiator and oil cooler clean. Normally, check
them daily and, if necessary, clean any debris off
these parts. Check and clean more frequently in dusty
and dirty conditions.
1. Prepare the machine for maintenance; refer to
Preparing the Machine for Maintenance (page
35)
.
2. Clean the outside of the screens in the hood
(
Figure 77 ).
48