g292377
Figure 44
1.
Hex plug
7.
Assemble a bolt (12 x 40 mm) and washer (12
mm) into the hole at the center of the motor end
plate (
g014451
Figure 45
1.
Front wheel motor
3.
Washer (12 mm)
2.
Hex plug
4.
Bolt (12 x 40 mm)
8.
Tighten the bolt in the threaded hole in
the brake piston until the brake releases
(
).
9.
Repeat steps
through
for the brake at the
left side of the machine.
Bypassing the Transmission
Pump
1.
Decommission the hydraulic service braking
system by turning the bypass valve (located
under the transmission pump) counterclockwise
(
), a maximum of 3 turns.
The mower is now in a freewheel condition and
can be towed for a short distance at slow speed.
Important:
You must manually steer the
machine while it is towed. When the engine
is shut off, there is no hydraulic steering
assist—steering the machine feels heavy.
g014450
Figure 46
1.
Transmission bypass valves
2.
Lower and latch the platform; refer to
the Platform (page 35)
.
3.
Remove the wheel chocks.
Towing the Machine
Important:
Do not tow the machine faster than
3 to 5 km/h (2 to 3 mph) and for no longer than
3 minutes; otherwise, internal damage to the
transmission may occur.
•
Use the front tow ring to tow the machine.
•
Tow the machine a short distance, at slow speed,
for no longer than 3 minutes.
29
