Toro GreensPro 1260, Руководство оператора

Страница: 31 / 36

7. Lubricate the sealing gasket, install the filter by
hand until the gasket contacts the filter head,
then tighten it 3/4 turn further.
Note:
The filter should now be sealed.
8. Remove the hydraulic-tank cap ( Figure 20 ).
9. Fill the tank with the proper fluid; refer to
Checking the Level of the Hydraulic Fluid (page
15)
.
10. Install the tank cap.
11. Wipe up any spilled fluid.
12. Start the machine and run it at low idle for 3 to 5
minutes to circulate the fluid and remove any air
trapped in the system.
13. Shut off the engine, check the level of the
hydraulic fluid, and add fluid if necessary.
14. Lower and latch the seat.
15. Dispose of the fluid and the filter according to
local codes.
Brake Maintenance
Checking and Adjusting the
Parking Brake
Service Interval: Before each use or daily
Ensure that the parking brake prevents the machine
from rolling when it is parked.
Adjust the parking brake as follows:
•
To increase the brake force, tighten the brake
locknut (
Figure 37 ).
•
To decrease the brake force, loosen the brake
locknut (
Figure 37 ).
g027634
Figure 37
1. Brake locknut
Note:
Ensure that the brake fully disengages when
the brake handle is in the disengaged position.
31