Toro Greensmaster Flex 2120, Руководство оператора

Страница: 37 / 44

Controls System
Maintenance
Adding Fluid to the Clutch
Assembly
Fluid specification: ATF D/M Automatic
Transmission Fluid (Toro Part No. 505-136)
1. Remove the vent from the breather from the
transmission assembly (
Figure 47 ).
g295805
Figure 47
1. Breather 3. Level plug
2. Vent 4. Drain plu
2. Remove the drain plug ( Figure 47 ) and allow the
transmission fluid to drain from the transmission
housing.
3. Add the specified fluid (296 ml or 10 fl oz)
through the breather opening.
4. Apply a light coating of clean motor oil (SAE 30)
onto the rubber portion of the seals and O-rings
(breather and level plug) prior to assembly.
5. Install drain plug to the clutch assembly and
torque it to 14 N∙m (10 ft-lbs).
6. Remove the level plug ( Figure 47 ) to confirm
fluid fill level.
7. Install the level plug and torque it to 14 N∙m (10
ft-lbs).
8. Install the vent to the breather. Tighten until
gasket contacts and then tighten an additional
80°.
Adjusting the Traction
Control
If the traction control does not engage or if it slips
during operation, an adjustment is necessary.
1. Move the traction control to the E
NGAGED
position.
2. Measure the distance from the pin on either
end of the traction-control spring (
Figure 48 ); if
it is not within 7.3 to 7.6 cm (2-7/8 to 3 inches),
adjust the clutch according to the steps below.
g032417
Figure 48
1. Measure this distance
(should be 7.3 to 7.6 cm
(2-7/8 to 3 inches). 4. Turnbuckle
2. Traction-control spring 5. Jam nut
3. Clevis pin
A. Disengage the traction-control lever.
B. Loosen the jam nut on the turnbuckle and
remove the clevis pin, disconnecting the
spring from the turnbuckle (
Figure 48 ).
C. Turn the turnbuckle in or out to adjust the
length as necessary.
D. Install the turnbuckle to the spring with the
clevis pin.
E. Move the traction control to the E
NGAGED
position.
F. Measure the distance from the pin on either
end of the traction-control spring (
Figure
48 ); repeat steps A through F until it is
within 7.3 to 7.6 cm (2-7/8 to 3 inches).
37