Adjusting the Handle
Height
Note:
The machine is shipped with the handle
adjusted to the lowest position. The machine is
normally operated with the handle telescoped out to
its maximum height.
1.
Loosen the 3 carriage bolts and nuts securing
each side of the handle in the handle clamps
(
).
g016851
Figure 24
1.
Handle clamp
3.
Carriage bolts
2.
Nut
2.
Pull up on the handle slowly and evenly on each
side until it is in the desired operating position.
3.
Tighten the carriage bolts and nuts to lock the
adjustment.
Adjusting the Handle Angle
1.
Remove the hairpin cotters from the handle
retainers on each side of the machine (
g017005
Figure 25
1.
Hairpin cotter
2.
Handle retainer
2.
While supporting the handle, remove the hairpin
cotters from each side and pivot the handle to
the desired operating position (
).
3.
Install the handle retainers and hairpin cotters.
Adjusting the Throttle
Control
1.
Remove the console cover.
2.
Loosen the 2 fasteners securing the throttle
control (
).
g027739
Figure 26
1.
Fasteners
2.
Throttle control
3.
Adjust the throttle control to the desired position.
4.
Tighten the throttle-control fasteners.
5.
Install the previously removed console cover.
20
