BREAK-IN PERIOD
1.
Only 8 hours of mowing operation is required for
the Greensmaster 3200-D break-in period.
2.
Since the first hours of operation are critical to
future dependability of the machine, monitor its
functions and performance closely so that minor
difficulties, which could lead to major problems, are
noted and can be corrected. Inspect the
Greensmaster 3200-D frequently during break-in for
signs of oil leakage, loose fasteners, or any other
malfunction.
3.
To assure optimum performance of the brake
system, break-in the brakes before use: Firmly
apply the brakes and drive the machine at mowing
speed until the brakes are hot, as indicated by their
smell. An adjustment to the brakes may be required
after break-in.
STARTING INSTRUCTIONS
IMPORTANT: The fuel system may have to be bled if
any of the following situations have occurred:
A.
Initial start up of a new engine.
B.
The engine has ceased running due to lack of fuel.
C.
Maintenance has been performed upon fuel system
components; i.e., filter replaced, etc.
Refer to Bleeding the Fuel System
1.
Be sure parking brake is set, the raise/lower/mow
control is disengaged and the functional control is
in neutral position.
2.
Remove your foot from the traction pedal and make
sure the pedal is in neutral.
3.
Move the throttle lever to the full-throttle position.
4.
Insert the key into the switch, turn it to the ON
position and hold it there until the glow plug
indicator light goes off (approximately 6 seconds).
5.
Immediately turn the key to START. Release the
key when the engine starts and allow it to move to
the ON position. Move the throttle control to the
SLOW position.
IMPORTANT: To prevent overheating the
starter motor, do not engage the starter longer
than 10 seconds. After 10 seconds of continuous
cranking, wait 60 seconds before engaging the
starter again.
6.
When the engine is started for the first time, or after
overhaul of the engine, operate the machine in
forward and reverse for one to two minutes.
Turn the steering wheel to the left and right to
check steering response. Then shut the engine off
and check for oil leaks, loose parts and any other
noticeable malfunctions.
7.
To stop the engine, move the throttle control to the
SLOW position, make sure the raise/lower/mow
control is disengaged and the functional control is
in the neutral position. Turn the starter key to OFF.
Remove the key from the switch to prevent
accidental starting.
8.
Close the fuel shut off valves before storing the
machine.
BLEEDING THE FUEL SYSTEM
(Fig.
14 & 15)
1.
Park the machine on a level surface. Make sure the
fuel tank is at least half full.
2.
Open the fuel shut-off valve under the fuel tank and
on the fuel filter.
17
Operation
Shut off the engine and wait for all moving parts
to stop before checking for oil leaks, loose parts
and other malfunctions.
CAUTION
