Toro E-Z Vac DFS 78556, Руководство оператора

Страница: 23 / 44

12
Installing the Weights
Parts needed for this procedure:
2 Caster weight (if needed)
2 Clevis pin
2 Hairpin cotter
6 Lock washer (3/8 inch)
1 Weight-mount bracket
6 Bolt (3/8 x 1 inch)
6
Flat washer (3/8 inch)
3 Flange nut (small flange–3/8 inch)
2 Carriage bolt (5/16 x 3/4 inch)
2 Flange nut (5/16 inch)
3 Front weight (48-inch, 52-inch, and 60-inch decks)
1
Front weight [72-inch decks (serial number 406294344
and below)]
2
Front weight [72-inch decks (serial number 406294345
and above)]
2 Tap bolt (3/8 x 1-3/4 inches)
2 Nut (3/8 inch)
Procedure
To comply with ANSI/OPEI B71.4-2004 Standard, you
must add weights to the machine.
CAUTION
The bagger adds a lot of weight to the rear
of the machine and may cause an unstable
condition, which could result in a loss of
control.
The following table shows what weights you use when
you install a bagger.
Front weights
used
Caster weights
used
48-inch mower
deck with bagger 3 0
52-inch mower
deck with bagger 3 0
60-inch mower
deck with bagger 3 2
Front weights
used Caster weights
used
72-inch machine
deck with bagger
(serial number
406294344 and
below) 1 2
72-inch machine
deck with bagger
(serial number
406294345 and
above) 2 2
1. Install caster weights on the front casters with a
clevis pin and hairpin cotter (
Figure 31 ).
2. Install the nut (3/8 inch) onto each tap bolt (3/8 x
1-3/4 inches) and install the tap bolts into each
weight (
Figure 31 ).
3. Tighten the tap bolt so that it touches the frame
and then tighten the jam nut against the weight.
g009224
Figure 31
1. Tap bolt (3/8 x 1-3/4
inches) 4. Hairpin cotter
2. Nut (3/8 inch) 5. Clevis pin
3. Caster weight 6. Install the tap bolt against
the frame and tighten the
nut.
4. Install the weight-mount bracket under the
footrest with 2 carriage bolts (5/16 x 3/4 inch)
and 2 flange nuts (5/16 inch).
23