11.
Join the upper and lower tubes with 3 bolts (#10
x 3/4 inches), 3 flat washers (7/32 inch), and 3
locknuts (#10) as shown in
.
g003392
Figure 28
1.
Lower tube
4.
Locknut (#10)
2.
Upper tube
5.
Bolt, (#10 x 3/4 inches)
3.
Flat washer (7/32 inch)
12.
Install the lower tube onto the blower housing
and secure it with the latches.
11
Installing the Belt Cover
Parts needed for this procedure:
1
Belt cover (from the Blower and Drive Kit)
Procedure
1.
Lower the mower deck to the lowest height-of-cut
position.
2.
Install the new belt cover so that the notches on
both sides go over the belt-cover supports and
secure the latch (
or
).
g009305
Figure 29
48- and 52-inch bagger shown
1.
Belt cover
3.
Notch
2.
Belt-cover support
g009303
Figure 30
60- and 72-inch bagger shown
1.
Belt cover
3.
Notch
2.
Belt-cover support
22
