Toro CT2120 30655, Руководство оператора

Страница: 7 / 64

object injuries. Do not resume mowing until the
area is cleared.
Maintenance and Storage
• Make sure all hydraulic line connectors are tight and
all hydraulic hoses and lines are in good condition
before applying pressure to the system.
• Keep your body and hands away from pin hole
leaks or nozzles that eject hydraulic fluid under
high pressure. Use paper or cardboard, not your
hands, to search for leaks. Hydraulic fluid escaping
under pressure can have sufficient force to penetrate
the skin and cause serious injury. Seek immediate
medical attention if fluid is injected into skin.
• Before disconnecting or performing any work on
the hydraulic system, all pressure in the system must
be relieved by stopping the engine and lowering the
cutting units and attachments to the ground.
• Check all fuel lines for tightness and wear on a
regular basis. Tighten or repair them as needed.
• If the engine must be running to perform a
maintenance adjustment, keep hands, feet, clothing,
and any parts of the body away from the cutting
units, attachments, and any moving parts. Keep
everyone away.
• To ensure safety and accuracy, have an Authorized
Toro Distributor check the maximum engine speed
with a tachometer. Maximum governed engine speed
should be 3000 RPM.
• If major repairs are ever needed or if assistance is
desired, contact an Authorized Toro Distributor.
• Use only Toro-approved attachments and
replacement parts. The warranty may be voided if
used with unapproved attachments.
Sound Power Level
This unit has a guaranteed sound power level of 105
dBA, which includes an Uncertainty Value (K) of 1 dBA.
Sound power level was determined according to the
procedures outlined in ISO 11094.
Sound Pressure Level
This unit has a sound pressure level at the operator’s
ear of 84 dBA, which includes an Uncertainty Value (K)
of 1 dBA.
Sound pressure level was determined according to the
procedures outlined in EN 836.
Vibration Level
Hand-Arm
Measured vibration level for right hand = 2 m/s
2
Measured vibration level for left hand = 2 m/s
2
Uncertainty Value (K) = 0.5 m/s 2
Measured values were determined according to the
procedures outlined in EN 836.
Whole Body
Measured vibration level = 0.7 m/s 2
Uncertainty Value (K) = 0.1 m/s
2
Measured values were determined according to the
procedures outlined in EN 836.
Safety and Instructional Decals
Safety decals and instructions are easily visible to the operator and are located near any area of
potential danger. Replace any decal that is damaged or lost.
70-13-072
1. Jacking point
70-13-077
1. Warning—stop the engine and remove the ignition key
before releasing or operating safety latches.
7