Toro CT2120 30655, Руководство оператора

Страница: 23 / 64

rises off the seat for a brief moment during normal
work, drive to the cutting cylinders is not affected.
The engine can only be started with the cutterhead
drive switch in the
OFF position.
WARNING
Do not operate the turf mower if the operator
presence controls are defective in any way.
Always
replace faulty parts and check that they function
correctly before operating the mower.
CAUTION
If safety interlock switches are disconnected or
damaged the machine could operate unexpectedly
causing personal injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock switches
daily and replace any damaged switches before
operating the machine.
Starting and Stopping the
Engine
Important:
You must bleed the fuel system before
starting the engine if you are starting the engine for
the first time, the engine has stopped due to lack
of fuel, or you have performed maintenance on the
fuel system; refer to Bleeding the Fuel System.
WARNING
Before starting the engine check that:
• You have read and understood the Safety
Precautions section in this manual.
• The area is clear of bystanders.
• The cutterhead drive is disengaged.
• The parking brake is engaged.
• The travel control pedals are in neutral.
Important:
This machine is fitted with an Engine
start lockout, refer to OPERATOR PRESENCE
CONTROLS.
Starting a Cold Engine
1. Sit on the seat, keep your foot off of the traction
pedals so that it is in Neutral, engage the parking
brake and set the throttle to the 70 percent full
throttle position.
2. Turn the ignition key to the ignition on position I
and check that the engine oil pressure and battery
charge warning lights illuminate.
3. Turn the ignition key to the preheat position II so
that the pre-heat indicator light is on. Hold it for 5
seconds to heat the glow plugs.
4. After preheating the glow plugs, turn key to the start
position III and hold to crank the engine.
Crank the engine for no longer than 15 seconds.
Release the ignition key back to position
I when the
engine starts.
5. Run the engine at low idle speed until it warms up.
1
G014557
Figure 28
1. Engine pre-heat indicator light
WARNING
When the engine is operating all warning lights
should be off. If a warning light illuminates, stop
the engine immediately and have the fault rectified
before restarting.
Starting a Warm Engine
1. Sit on the seat, keep your foot off of the traction
pedal so that it is in Neutral, engage the parking
brake and set the throttle to the 70 percent full
throttle.
2. Turn the ignition key to the ignition on position I
and check that the engine oil pressure and battery
charge warning lights illuminate.
3. Turn the ignition key to the start position III and
hold to crank the engine.
Crank the engine for no longer than 15 seconds.
Release the ignition key back to position
I when the
engine starts.
4. Run the engine at low idle speed until it warms up.
Stopping the Engine
1. Move all controls to Neutral, set the parking brake,
move the throttle to the low idle position and allow
the engine to reach low idle speed.
Important:
Allow the engine to idle for 5
minutes before shutting it off after a full load
operation. Failure to do so may lead to trouble
on a turbo-charged engine.
23