11
Installing the Weights for a
52-inch Bagger
Parts needed for this procedure:
2
Weight
2
Bolt (3/8 x 3 inches)
2
Locknut (3/8 inch)
4
Washer (3/8 inch)
Procedure
To comply with ANSI/OPEI B71.4-2012 Standard, add front
weight to the machine.
CAUTION
The bagger adds a lot of weight to the rear of the
machine and may cause an unstable condition
which could result in a loss of control.
1.
Install 2 bolts (3/8 x 3 inches) and 2 washers (3/8 inch)
to the frame under the foot rest (
).
2.
Install the weights, with the decal facing the front, to
the bolts with 2 washers (3/8 inch) and locknut (3/8
inch) under the frame (
Figure 34
1.
Bolt, (3/8 x 3 inches)
4.
Weight
2.
Washer, (3/8 inch)
5.
Locknut, (3/8 inch)
3.
Frame
6.
Decal on the weight
positioned to the front of
the machine
12
Adjusting the Parking Brake
No Parts Required
Procedure
Check to make sure the parking brake is adjusted properly.
Refer to your
Operator’s Manual
for the correct procedure.
17
