Toro 78281, Руководство оператора

Страница: 6 / 20

6
1
5
3
6
1783
4
2
Figure 5
1. Bracket
2. Spring hook end
3. space for spring
4. Grass deflector
5. Bolt 3/8–3-1/2 in. (89 mm)
6. Lock nut 3/8 in.
An uncovered discharge opening could allow the
lawn mower to throw objects in the operator’s or
bystander’s direction and result in serious injury.
Also, contact with the blade could occur.
•
Never remove the grass deflector from the
mower because the grass deflector routes
material down toward the turf. If the grass
deflector is ever damaged, replace it
immediately.
•
Never put your hands or feet under the mower.
•
Never try to clear discharge area or mower
blades unless you move the power take off
(PTO) to off and rotate the ignition key to off.
Also remove the key and pull the wire off the
spark plugs.
Warning
Preparing the Tractor
1. Park the machine on a level surface and lower
attachment lift to the full down position. Refer to Using
the Attachment Lift lever on page 11.
Note: Turn Dial-A-Height control to allow lift to go to full
mounting position.
2. Adjust air pressure in tires to recommended pressure.
3. Adjust transport height nut until bottom of rear lift arms
are approximately 7-1/4 in. (188 mm) from the level
surface (Fig. 6).
2
3
1
m–2399
Figure 6
1. Transport height nut
2. Rear lift arms
3. 7-1/4 in. (188 mm)
4. Raise attachment lift to the full up position. Refer to
Operation: Attachment Lift page 11.
5. Remove E-ring, washer and lift link from front lift arm
(Fig. 7).
6. Hold front lift arm up until stop contacts frame (Fig. 7).
7. Push back hard on lift rod, to raise linkage, and check
location of lift rod compared to mounting hole location.
8. Adjust length of lift rod, by turning in\out of trunnion,
so end just slides into mounting hole in front lift arm
(Fig. 7).
9. Slide lift rod into hole and secure with previously
removed washer and E-ring (Fig. 7).
10. Check that stop is 0–1/8 in. (0–3 mm) away frame when
fully assembled and lift in the full up position.
2
m–3398
4
1
3
5
Figure 7
1. E-ring
2. Washer
3. Stop on lift arm
4. Lift link
5. Trunnion
11. Remove bolts securing existing up-stop to tractor frame
(Fig. 8).