15
Operation
Figure 8
Retaining
Cap
Figure 9
Dangerous
Cutting Area
Direction of
Rotation
Best Cutting
Area
To Advance the Cutting Line
See Figure 8.
Line advance is controlled by tapping the string head on
grass while running engine at full throttle.
1.
Run engine at full throttle.
2.
Tap the knob on ground to advance line. The line advances
each time the knob is tapped. Do not hold the knob on the
ground.
Note:
The line trimming cut-off blade on the grass deflector
will cut the line to the correct length.
Note:
If the line is worn too short you may not be able to
advance the line by tapping it on the ground. If so, stop the
engine and manually advance the line.
To advance the cutting line manually:
1.
Stop the engine and disconnect the spark plug wire.
2.
Push the knob in while pulling on line(s) to manually
advance the line.
Cutting Tips
See Figures 7 and 9.
1.
Avoid hot surfaces by always keeping the tool away
from your body. (Proper operating position is shown in
figure 7.)
2.
Keep the trimmer tilted toward the area being cut; this is
the best cutting area.
3.
The trimmer cuts when passing the unit from left to
right. This will avoid throwing debris at the operator.
Avoid cutting in the dangerous area shown in figure 9.
4.
Use the tip of string to do the cutting; do not force string
head into uncut grass.
5.
Wire and picket fences cause extra string wear, even
breakage. Stone and brick walls, curbs and wood may
wear string rapidly.
6.
Avoid trees and shrubs. Tree bark, wood moldings,
siding and fence posts can easily be damaged by the
string.
Содержание 51998
Страница 25: ...25 Notes...
