Toro 51488, Руководство оператора

Страница: 13 / 16

Replacing the String
1. Remove the battery.
2. Remove the spool. See Replacing the Spool ( Figure 19 ).
Figure 20
1. Slot in upper spool flange 3. Slot in lower spool flange
2. Hole
Note:
Remove any old string remaining on the spool.
3. The spool will accept up to 4.5 m (15 feet) of string. Use
only 1.6 mm (.065 inch) diameter monofilament string.
Note:
Do not use any other gauge or type of string, as
this could damage the trimmer.
4. Insert the string into the anchor holes in the upper part of
the spool (
Figure 20 ). Wind the string onto the spool in the
direction shown by the arrows on the spool.
5. Place the string in the slot on the upper spool flange, leaving
about 152 mm (6 inches) extended beyond the slot.
6. Repeat steps 4 and 5 for the lower string.
Note:
Do not overfill. After winding the string, there
should be at least 6 mm (1/4 inch) between the wound
string and the outside edge of the spool.
7. Replace the spool and the spool retainer. Refer to Replacing
the Spool (page 12) .
Preparing the Battery Pack For
Recycling
WARNING
Upon removal, cover the battery pack's terminals with
heavy-duty adhesive tape. Do not attempt to destroy
or disassemble the battery pack or remove any of its
components. Lithium-ion batteries must be recycled or
disposed of properly at the nearest battery recycling
facility.
Service
Should this item need service, take the product to your Authorized
Toro Service Dealer. Your Toro Dealer is specially trained to repair
Toro products and will ensure that your Toro stays “All” Toro.
Storage
•
Clean all foreign material from the product.
•
Store it in a well-ventilated place that is inaccessible to
children.
•
Keep away from corrosive agents such as garden chemicals
and de-icing salts.
•
Use the storage mode on the battery charger if it will be
unused for 1 month or longer. Refer to
Charging the Battery
Pack (page 9) .
Troubleshooting
Using the battery when it is hot can reduce the operating time.
The battery will automatically stop working when it is overheated
to prevent damage to it. Remove the battery from the charger and
allow it to cool before placing it back into the trimmer.
Using the battery when there is moisture on the leads can cause
the trimmer to malfunction. Allow the battery to dry or wipe it dry
before placing it back into the trimmer.
Using the trimmer to cut thick grass in temperatures above 32° C
(90° F) may reduce the run time. Decrease the motor speed to
help increase the operating time; refer to (
Starting the Trimmer
(page 8) .
Failing to clear debris from the trimmer head vents and shaft may
result in reduced run time. The trimmer may also stop working
when it is overheated to prevent damage to the trimmer. Clear
debris from the air vents on the motor housing and shaft and allow
the trimmer to cool before attempting to use the trimmer again.
Refer to
(page )
If it is difficult to remove the battery from the trimmer or the
charger, apply some dielectric grease to the battery terminals.
Do
not use any other type of lubricant as it can cause damage to the
terminals. Refer to Removing the Battery (page 9) .
13