Toro 51488, Руководство оператора

Страница: 9 / 16

Stopping the Trimmer
To stop the trimmer, release the trigger ( Figure 8 ).
Removing the Battery
To remove the battery from the trimmer, grip the handle, press
down on the latch, and pull the battery out of the cavity.
Figure 10
1. Handle 3. Latch
2. Battery housing
Note:
Do not grip the housing around the battery. This will
make it more difficult to remove the battery from the trimmer.
Note:
If you have trouble removing the battery, apply some
dielectric grease to the battery terminals ( Figure 11 ). Do not
use any other type of lubricant as it can cause damage to the
terminals.
Figure 11
1. Battery terminals
Charging the Battery Pack
Important:
For best results, your battery tool should
be charged in a location where the temperature is more
than 5° C (41° F) but less than 40° C (104° F). To reduce
the risk of serious personal injury, do not store outside
or in vehicles. Charging time will be increased if not
charged within this range.
1. If the power cord is not plugged in to the charger, plug it in
to the charger (
Figure 12 ), then plug the power cord into
a power socket.
2. Turn the battery upside down and line up the battery terminal
with the slot in the charger (
Figure 12 and Figure 13 ).
Figure 12
1. Insert battery here 3. Charge/storage mode
switch
2. LED indicators 4. Power cord plug-in
location
Figure 13
1. LED indicators (level of
charge) 3. Battery terminal
2. Release button 4. Test button
3. Slide the battery into the charger until it clicks into place.
4. Hold down the charger, pull up on the release button, and
slide the battery backward out of the charger.
9