8.
After each adjustment, allow the conveyor belt
to rotate for at least 10 rotations to position itself
to the new alignment before making any further
corrections.
9.
If the belt is working properly again, securely
lock the screws in place.
Cleaning the Machine
Service Interval:
After each use
Important:
Do not use brackish or reclaimed
water to clean the machine.
•
After daily use, thoroughly wash the machine
with a garden hose (
without
a nozzle) to avoid
contamination and seal and bearing damage due
to excessive water pressure.
Note:
Use a brush to help remove thick layered,
dried, or compacted dirt and debris.
•
Use a mild detergent to clean the covers.
•
Inspect the machine for damage, leaking oil, and
component wear.
•
After cleaning the machine, grease all drive
lines and roller bearings; refer to
Attachment (page 21)
.
Installing the Cutter Knives
1.
Install the far left knives with the L pointing to
the right.
2.
Install all remaining knives with the L pointing
to the left.
g346660
Figure 33
1.
Knives pointing to the right
2.
Knives pointing to the left
24
