Toro 46450, Руководство оператора

Страница: 10 / 32

1. Park the machine on a level surface, engage
the parking brake, and lower the attachment to
the ground.
2. Shut off the engine and remove the key.
3. Pull the PTO driveshaft sections apart ( Figure 9 ).
g347461
Figure 9
4. Assemble the outer PTO driveshaft section to
the traction-unit PTO output shaft (
Figure 10 ).
Note:
Pull on the driveshaft to ensure that the
locking pin engages the PTO output shaft.
g007328
Figure 10
1. PTO output shaft (traction
unit) 3. PTO driveshaft
2. PTO shaft coupler
5. Hold the driveshaft sections parallel to each
other to determine if they are too long (
Figure
11 ).
Note:
Each driveshaft section must be 76 mm
(3 inches) from the U-joint ( Figure 11 ).
6. If the driveshaft sections are too long, mark 76
mm (3 inches) back from U-joint on each section
(
Figure 11 ).
g347524
Figure 11
1. 76 mm (3 inches) 3. Traction-unit PTO output
shaft
2. Attachment gearbox
7. Remove and cut each section at the mark
(
Figure 12 ).
Note:
Ensure the same amount is removed
from each section.
g347473
Figure 12
1. Cut the driveshaft section.
8. Deburr the ends of the sections ( Figure 13 ).
10