Toro 41393, Руководство оператора, Страница: 52 / 92

g002014
Figure 64
Right Boom
1. Grease fitting
3. Wipe off excess grease.
4. Repeat the procedure for each boom pivot.
Greasing the Actuator-Rod
Bearings
Service Interval: Every 400 hours/Yearly (whichever
comes first)
Grease Type: No. 2 lithium grease.
1. Lower the outer spray sections to the
SPRAY
position.
2. Remove the hairpin from the clevis pin ( Figure
65 ).
3. Lift up on the section, remove the clevis pin, and
slowly lower the section to the ground (
Figure
65 ).
4. Inspect the clevis pin for damage, and replace it
if necessary.
g013780
Figure 65
1. Actuator 4. Hairpin
2. Actuator rod 5. Clevis pin
3. Boom-pivot-pin housing
5. Swivel the rod-end bearing and apply grease
into the bearing (
Figure 66 ).
Note:
Wipe off excess grease.
g002015
Figure 66
Right Boom
1. Grease the rod-end bearing
6. Lift the spray section to align the pivot with the
actuator rod.
7. While supporting the spray section, insert the
clevis pin through both boom pivot and actuator
rod (
Figure 65 ).
8. With the pin in place, release the spray section
and secure the clevis pin with the hairpin
removed previously.
52