Operating the Spray
Sections
The boom-section lift switches on the sprayer control
panel allows you to move the outer spray sections
between transport position and spray position without
leaving the operator's seat. Whenever possible, stop
the machine before changing spray section positions.
1.
Stop the sprayer on level ground.
2.
Use the boom-section lift switches to lower the
outer spray sections.
Note:
Wait until the sections reach the
fully-extended spray position.
3.
When you need to raise the spray sections, stop
the sprayer on level ground.
4.
Use the boom-section lift switches to raise the
sections.
Note:
Raise the sections until they have moved
completely into section transport cradle, forming
the “X” transport position and the section
cylinders are fully retracted.
Important:
To prevent damage to the
section-actuator cylinder, ensure that the
actuators are fully retracted before transport.
Important:
Release the actuator switch once the
outer spray sections have reached the desired
position. Running the actuators against the
mechanical stops may damage the lift cylinders
and/or other hydraulic components.
Operating the Boom-Transport
Cradle
The sprayer is equipped with a boom-transport cradle
that has a unique safety feature. In the event of
accidental boom contact with a low overhead object
while in the transport position, the boom(s) can be
pushed out of the transport cradles. If this occurs, the
booms will come to rest in a near-horizontal position
to the rear of the vehicle. While this movement will
not damage the outer spray sections, they should be
immediately put back into the transport cradle.
Important:
The outer spray sections can be
damaged by transporting them in any position
other than the “X” transport position using the
boom transport cradle.
To put the boom sections back into the transport
cradle, lower the boom section(s) to the spray
position, and then raise the boom section(s) back into
the transport position. Ensure that the lift cylinders
are fully retracted to prevent actuator rod damage
during storage.
Sprayer Functions for
Application Rate Mode and
Manual Mode
Refer to the
Software Guide
for the Multi Pro 5800-D
and 5800-G turf sprayers with ExcelaRate spray
system for information on the following:
Before Operation
•
The InfoCenter home screen
•
The main menu screen
•
The main menu sub-screens
•
The service screens
•
The diagnostic screens
•
The About screens
During Operation
•
Entering job information
•
InfoCenter spray-area screens
•
InfoCenter advisories
Spraying with the
ExcelaRate Sprayer System
Refer to the
Software Guide
for the Multi Pro 5800-D
and 5800-G turf sprayers with ExcelaRate spray
system for information on the following procedures:
Important:
To ensure that the product remains
well mixed, use the agitation feature whenever
you have solution in the tank.
Spraying in the Application Rate
Mode
1.
Ensure that the spray system is calibrated
for the active spray nozzles that you have
selected; Refer to the
Software Guide
for the
Multi Pro 5800-D and 5800-G turf sprayers with
ExcelaRate spray system.
2.
Rotate the knob for the section-bypass shutoff
valve to the closed position (
).
32
Содержание 41393
Страница 88: ...Schematics g034336 Sprayer System Schematic Rev DWG 131 9559 Rev A 88...
Страница 89: ...Notes...
Страница 90: ...Notes...